|

Simulation of Gas Flow in Channels with Variable Cross-Section at Different Flow Modes using Lattice Boltzmann Method (LBM)

Authors: Burmistrov A.V., Salikeev S.I., Raykov A.A. Published: 23.12.2019
Published in issue: #6(129)/2019  

DOI: 10.18698/0236-3941-2019-6-105-115

 
Category: Power, Metallurgic and Chemical Engineering | Chapter: Vacuum, Compressor Technology, and Pneumatic Systems  
Keywords: channels of variable cross-section, gas flow, conductivity, mass flow rate, viscous mode, molecular mode, transient mode, fluid dynamics equations

All contact-free vacuum pumps operate in a very wide pressure range. Therefore, the calculation of flows through the slot channels is associated with the need to take into account the laws of all three modes of gas flow: viscous, transitional and molecular. Most of channels of contact-free pumps are formed by curved walls, which are slits of variable cross-section in the direction of gas flow, having a minimum gap in some place. The paper considers the basic methods of calculating flows in channels of variable cross-section: the Monte Carlo method for molecular mode, the numerical solution of Navier --- Stokes equations for viscous mode and the Lattice Boltzmann method (LBM) for a wide range of pressures. The results of gas flow simulation calculated in COMSOL Multiphysics with LBM method are presented. The influence of the gas flow mode on the velocity profile in the channel is discussed. Based on the simulation results, the conductivity of channels of different geometries was calculated at various pressures at the inlet and outlet of the channel. The graphs of conductivity dependence on the Knudsen number for the method of angular coefficients, the model of lattice Boltzmann equations and experimental data are presented. It is shown that for slit channels of variable cross-section, the LBM model agrees well with the experiment under any gas flow modes

References

[1] Zakharenko S.E. Gas flow rate through narrow slits at critical exhaust velocity. Trudy LPI, 1965, no. 1, pp. 71--74 (in Russ.).

[2] Sakun I.A. Vintovye kompressory [Screw compressors]. Leningrad, Mashinostroenie Publ., 1970.

[3] Ginzburg I.P. Gas motion in narrow slit. Vestnik Leningradskogo universiteta. Mekhanika, 1953, no. 8, pp. 27--50 (in Russ.).

[4] Khisameev I.G., Maksimov V.A. Dvukhrotornye vintovye i pryamozubye kompressory [Two-rotor screw and straight-toothed compressors]. Kazan, FEN Publ., 2000.

[5] Burmistrov A.V., Sharafiev L.Z., Salikeev S.I., et al. [A method for the rapid conductivity calculation of slot channels formed by curvilinear walls with arbitrary geometry]. Mat. XII nauch.-tekh. konf. "Vakuumnaya nauka i tekhnika" [Proc. XII Sc.-Tech. Conf. Vacuum science and technique]. Moscow, MIEM Publ., 2005, pp. 37--41 (in Russ.).

[6] Salikeev S., Burmistrov A., Bronshtein M., et al. Conductance calculation of channels in laminar gas flow regime at an arbitrary pressure difference. Vacuum, 2014, vol. 107, pp. 178--183. DOI: 10.1016/j.vacuum.2014.01.016

[7] Ansys, Inc. License file for Kazan National Research Technology University c/n 657938.

[8] Bird G.A. Molecular gas dynamics. Oxford, Clarendon, 1976.

[9] Bird G.A. Molecular gas dynamics and the direct simulation of gas flows. Oxford, Clarendon Press, 1994.

[10] Salikeev S., Burmistrov A., Bronshtein M., et al. Conductance of slot channels formed by cylindrical walls: Monte Carlo calculations and experimental studies in the molecular gas flow regime. Vakuum in Forschung und Praxis, 2013, vol. 25, no. 4, pp. 34--38.

[11] Dushman S. Scientific foundation of vacuum technique. New York, John Wiley & Sons, 1949.

[12] Burmistrov A., Salikeev S., Bronshtein M., et al. Conductance calculation of slot channels with variable cross section: from molecular to viscous flow regime. Vakuum in Forschung und Praxis, 2015, vol. 27, no. 1, pp. 36--40.

[13] Bhatnagar P.L., Gross E.P., Krook M. A model for collision processes in gases. I. Small amplitude processes in charged and neutral one-component systems. Phys. Rev., 1954, vol. 94, no. 3, pp. 511--525. DOI: 10.1103/PhysRev.94.511

[14] Agarwal R.K. Beyond Navier --- Stokes: Burnett equations for flows in the continuum-transition regime. Phys. Fluids, 2001, vol. 13, no. 10, pp. 3061--3085. DOI: 10.1063/1.1397256

[15] COMSOL Multiphysics. License file for Kazan National Research Technology University c/n 9601045.

[16] Sharipov F. Analytical and numerical calculations of rarefield gas flow. In: Handbook of vacuum technology. Berlin, Wiley-VCN, 2008.

[17] Sturnfield J. Understanding the transition flow region through COMSOL Multiphysics modeling. Conf. COMSOL, Boston, 2015. URL: https://www.comsol.com/paper/download/257821/sturnfield_presentation.pdf

[18] Burmistrov A.V. Sozdanie i issledovanie beskontaktnykh vakuumnykh nasosov. Dis. d-ra tekh. nauk [Development and research of no-touch vacuum pump. Dr. Sc. (Eng.) Diss.]. Moscow, BMSTU Publ., 2006.